Diferencia entre revisiones de «Mecanismo de exposición para Láminas - Matilde, Andrés, Carla, Alejandra»
De Casiopea
Sin resumen de edición |
Sin resumen de edición |
||
Línea 1: | Línea 1: | ||
{{Exposición | {{Exposición | ||
|Título= | |Título=Mecanismo de exposición para Láminas | ||
|Palabras Clave=objetoeducativo | |Palabras Clave=objetoeducativo | ||
}} | }} |
Revisión del 17:27 27 may 2022
Mecanismo de exposición para Láminas, | |
Palabras Clave | objetoeducativo |
Título | Mecanismo de rieles de exposición para Láminas |
---|---|
Tipo de Proyecto | Proyecto de Curso |
Palabras Clave | Arduino, interacción, motor, exposición |
Período | 2022-2022 |
Asignatura | Interacción y Performatividad |
Del Curso | Interacción y Performatividad 2022 |
Carreras | Diseño, Interacción y Servicios"Interacción y Servicios" is not in the list (Arquitectura, Diseño, Magíster, Otra) of allowed values for the "Carreras Relacionadas" property. |
Alumno(s) | Carla Gómez Guerra, Matilde Croxatto Ullrich, Andrés Aliaga Chandía, Alejandra Witto Royo |
Profesor | Renzo Varela |
Código para probar la funcionalidad de los 2 botones
/*
DigitalReadSerial
Reads a digital input on pin 2, prints the result to the Serial Monitor
This example code is in the public domain.
https://www.arduino.cc/en/Tutorial/BuiltInExamples/DigitalReadSerial
- /
// digital pin 2 has a pushbutton attached to it. Give it a name: int pushButton1 = 2; int pushButton2 = 4;
// the setup routine runs once when you press reset: void setup() {
// initialize serial communication at 9600 bits per second: Serial.begin(9600); // make the pushbutton's pin an input: pinMode(pushButton1, INPUT); pinMode(pushButton2, INPUT);
}
// the loop routine runs over and over again forever: void loop() {
// read the input pin: int buttonState1 = digitalRead(pushButton1); int buttonState2 = digitalRead(pushButton2); // print out the state of the button:
/* Serial.print("boton 1: ");
Serial.println(buttonState1); Serial.print("boton 2: "); Serial.println(buttonState2); delay(100); // delay in between reads for stability
- /
if(buttonState1==1){ Serial.println("mueve motor 1"); }
if(buttonState2==1){ Serial.println("mueve motor 2"); }
delay(100); }