Código IDE C7

/*

 Button

Turns on and off a light emitting diode(LED) connected to digital  
pin 13, when pressing a pushbutton attached to pin 2. 


The circuit:
* LED attached from pin 13 to ground 
* pushbutton attached to pin 2 from +5V
* 10K resistor attached to pin 2 from ground

* Note: on most Arduinos there is already an LED on the board
attached to pin 13.


created 2005
by DojoDave <http://www.0j0.org>
modified 30 Aug 2011
by Tom Igoe

This example code is in the public domain.

http://www.arduino.cc/en/Tutorial/Button
*/

// constants won't change. They're used here to // set pin numbers: const int buttonPin = 2; // the number of the pushbutton pin const int ledPin = 13; // the number of the LED pin

// variables will change: int buttonState = 0; // variable for reading the pushbutton status

void setup() {

 // initialize the LED pin as an output:
 pinMode(ledPin, OUTPUT);      
 // initialize the pushbutton pin as an input:
 pinMode(buttonPin, INPUT);     

}

void loop(){

 // read the state of the pushbutton value:
 buttonState = digitalRead(buttonPin);

 // check if the pushbutton is pressed.
 // if it is, the buttonState is HIGH:
 if (buttonState == HIGH) {     
   // turn LED on:    
   digitalWrite(ledPin, HIGH);  
 } 
 else {
   // turn LED off:
   digitalWrite(ledPin, LOW); 
 }

}